I've been rolling on the three boats here for some time now. The Black & Green Blazer is in the final tuning stage. I have to do that on the water. The Champion is ready to wet too. Poor Skeeter has been on the hind tit so to speak till a few days ago.

Name: Finishing the Skeeter 1.jpg Views: 201 Size: 73.7 KBName: Finishing the Skeeter 2.jpg Views: 201 Size: 63.4 KBName: Finishing the Skeeter 3.jpg Views: 200 Size: 91.0 KB

Figuring out where to mount the RAM Mount Balls for the Plotter/Fishfinder & Panoptix Transducer Stick burnt up a few brain cells. I use blue tape the mark where to mount stuff like this so I can clear everything else out of the way while drilling & mounting.

Name: Finishing the Skeeter 4.jpg Views: 205 Size: 71.0 KB

There's always a bump in the road, the power cord for the Plotter has a built in fuse holder. Since that & the Panoptix power is all that is needed on the bow I'm not using a terminal block. Once I split the fuse holder it went right thru the hole. Terminations were done inside, if I happen to blow the Plotter fuse I will have to open the switch panel to replace it. Since I have never, ever blown a Plotter fuse I expect I won't need to replace the fuse anytime soon.

Name: Finishing the Skeeter 5.jpg Views: 188 Size: 85.8 KB

Now the bow is all closed up. I can't make the final Trolling Motor transducer cable till the boat is in the water I left some available slack in case it's needed.