Quote Originally Posted by E-Z Poleholder View Post
I have a 798 in the dash and a 1198 next to the console. I have dual ducers for the 1198 and have the 798 ducer within 8 inches of one of the 1198 ducers. The 1198 is connected to the battery and the 798 is through the master fuse panel. Voltage is not a problem. All the ducer wires are run from the back togather. Problem, I get some lines on both units as long as they both are powered on. Turn one off, the lines go away. Turn the motor off and no change.
Any ideas?
Anytime you run two units that operate on the same frequency, you will get interference. It will normally start to be a problem when the water depth gets as deep as the separation between the transducers. If you can run one of the units on a different frequency that should help.