Reply With Quoteby chance, is the motor not "locking" in place where the pin "pops" into the mounting bracket when you let the motor down? That is all I can think of. Possibly one side it popping in place and the other isn't...just a thought.
mrwillis
Likes: 0
Thanks: 0
HaHa: 0
Crappie Wall Hanger
TM Shakes
Have a relatively small Motor Guide TM (37 #). When I step on pedal to move, the entire motor shakes from side to side until in finally settles down. So, if I just want to creep up a little, the motor shakes and causes the boat to sway from side to side. I've tried to figure out what is causing it but I'm at a loss. Any ideas?
GET THE NET HAROLD, GET THE NET!!
Crappie Wall Hanger II
by chance, is the motor not "locking" in place where the pin "pops" into the mounting bracket when you let the motor down? That is all I can think of. Possibly one side it popping in place and the other isn't...just a thought.
mrwillis
Crappie.com 1K Star General
Bent shaft or missing a blade on your propeller.
PB Wht. Crappie 2.48 lbs 02-12-2011
Crappie Wall Hanger
Thanks for the replies; but, nope it is neither of those. Plan on taking it to a nearby repair shop. Again, thanks for taking the time.
GET THE NET HAROLD, GET THE NET!!
Crappie.com 3K Star General
At my age I sometimes shake like that til my 2nd cup of Coffee in morning:o
I don't suffer from insanity; I enjoy every minute of it.....
PROUD MEMBER OF TEAM GEEZER
Crappie.com Legend
Take the prop off look and see if there is any fishing line wrapped behind it. Also run it as slow as you can with the prop off and see if the prop shaft is bent. Also move the prop shaft back and forth see if the bearing is shot. Other than that maybe the mount is worn out and it's time to get a new MK Terrova with I-pilot.
BamaMan
Crappie Wall Hanger
Good googly moogly. New motor with remote!!! I love the way you think. Wonder if the wife would notice?
GET THE NET HAROLD, GET THE NET!!
Crappie.com Legend
Check the balance on the prop. I had a similar problem on a similar motor. I checked balance and used lead tape on the inside surface of the prop hub to balance it. Most of the vibration went away. I would change props if it is really out of balance.
Keith
2008 NWR Bash Crappie Champion
2010 NWR Bash Yellow Perch Champion
2010 Buggs Bash Smallest Crappie Award
Crappie.com Legend
Gansett, A man can never have to many remotes!:D Let me tell you man get you one they are nice!!! I got me one and I don't miss the wife at all!!!:DOriginally Posted by Gansett
Know J/K I love my wife, she has put up with me for 25 years!!!
BamaMan
Crappie Wall Hanger
BamaMan that was some funny stuff!! Heck, I'm still laughing. :D:D
Seriously though I did find the problem and it is not good. As I looked closer it became obvious that the shaft is bent. Thanks for everyone's help.
Also, come on over and visit with me and wife in ouir RV for the Iron Bowl on the Plains in 2011:rolleyes: Heck, come see us anytime, if you're that funny on line you gotta be something else in person,
GET THE NET HAROLD, GET THE NET!!
Posting Permissions
