Reply With QuoteThe installation instructions says line the middle line on the transducer with the bottom line of the boat.
Likes: 0
Thanks: 0
HaHa: 0
Crappie.com Legend
.Originally Posted by frontierman
That a tremendous help....... I will have to relocate my 2d ducer to an area similar to yours I think..... Either that or I might have enough of a gap between the back of the step and the LSS ducer to keep it where I have it..... If all else fails I'll just do shoot through hull with the 2D ...... Didn't really want to go through hull because of H2O temp readings .......but I def want depth readings on plane ....... Again that pic helps a ton, thank you
Slabmaster II
The installation instructions says line the middle line on the transducer with the bottom line of the boat.
Slabmaster II
Crappie.com Legend
My current 2D ducer is in a spot that I'm pretty confident will interfere with my side scan readings..... My current 2 D ducer reads on plane and is in a good spot, but when I put my new unit on the boat I'll have to relocate the 2d ducer to keep it out of the LSS beam...... It looks like I can do something similar to what you've done
Slabmaster II
I guess the reason I'm not having a problem with interface is because the water I'm facing in not that deep
10-30 ft.
But I'll test it out in deeper water and see of I'll get interface Just to see.
Slabmaster II
What does the cone look like for structure scan?
Crappie.com 2016 Man of the Year
* Member Sponsor
The SI "thin slice" beams are very wide top to bottom ... but very thin front to back (approx. 3° front to back) ...
The below depiction is for the HB 800kHz SI beam ... But the LSS 2 is similar ...
Rickie
www.podunkideas.com <--Click here
------------—————
https://www.crappie-gills-n-more.com/
https://cornfieldfishinggear.com/
------------------------>> Pro Staff Sonar Advisor
