Name: Wiring and Finishing 1.jpg Views: 56 Size: 116.6 KBName: Wiring and Finishing 2.jpg Views: 54 Size: 111.4 KBName: Wiring and Finishing 3.jpg Views: 55 Size: 72.3 KBName: Wiring and Finishing 4.jpg Views: 55 Size: 95.4 KB

I made a all new wiring harness for the vessel. First pulling everything in and securing the wire bundles well for days the wind will not stop blowing. Roughing in first is how I like to do it.

Name: Wiring and Finishing 5.jpg Views: 53 Size: 100.7 KBName: Wiring and Finishing 6.jpg Views: 53 Size: 98.0 KB

After spotting the batteries new trolling motor breaker and battery switch was mounted. The Fuel tank was installed and hoses reconnected. The fill hose for the livewell and bilge discharge were connected, wires secured, and a final check of the boat's wiring was tested.

Name: Wiring and Finishing 7.jpg Views: 55 Size: 71.6 KBName: Wiring and Finishing 8.jpg Views: 51 Size: 104.6 KB

These is still work to be done. Some of the switches bought were wrong, the electronics supply lines were run but not connected, the GLS10 box in the Livescope system was not mounted but all wires were pulled. After over a week of work my Bud pulled his boat home to finish up what was left. I had high hopes of picking it up off the trailer to recarpet the bunks but time didn't allow for that. Hopefully we can get that done soon.