So after finding the hose laying in the bottom of the boat I disconnected it from the Transom fitting and discovered the hose clamps were not even tight. Silicone was on the Hose Barbs so I think these hoses had been leaking in the past. I assume the Bow Livewell Drain hose shrunk and just pulled off the barb. I replaced the Drain Hose to the Aft Livewell. Used 2 clamps on each end of the hose too.

Name: Fixing the Livewell Drains 1.jpg Views: 103 Size: 80.6 KB

Look at the hole, no wonder the bilge pump couldn't keep up.

Name: Fixing the Livewell Drains 3.jpg Views: 107 Size: 57.0 KBName: Fixing the Livewell Drains 5.jpg Views: 107 Size: 96.8 KBName: Fixing the Livewell Drains 2.jpg Views: 103 Size: 108.1 KBName: Fixing the Livewell Drains 4.jpg Views: 108 Size: 51.2 KB

I mixed up a very stiff thickened epoxy and using a epoxy syringe I back filled the fitting from the inside pumping the epoxy against the bondo spreader taped over the opening on the outside. Once the fitting was filled I cut a .750 hardwood dowel and buttered it with the remaining epoxy then inserted it into the fitting for added insurance. The double clamps will ensure no water leaks.