Thread: Bobber Stopper

I use the same ones G does. Found they are easiest on line and guides.

Dental ruberbands for braces .

Bought a gadget a few years ago that makes them, I used waxed thread.

Originally Posted by "G"

I like the football shaped rubber ones from BPS....the go thru the rod guides good without hanging up on them....they have a wire loop thru them....just run your line thru the loop and pull the bobber stop off the wire and its on your line, throw the wire away. Been using them for years....to adjust lust slide the bobber stop up or down your line.

good and cheap. I buy them and lose them before I use them. then go buy another 100 or so only to lose them too.

What's wrong with the ones i use, just dont pull them so tight... if you want , i got pleanty of them

Originally Posted by "G"

I like the football shaped rubber ones from BPS....the go thru the rod guides good without hanging up on them....they have a wire loop thru them....just run your line thru the loop and pull the bobber stop off the wire and its on your line, throw the wire away. Been using them for years....to adjust lust slide the bobber stop up or down your line.

fly reel backing works great. Day Bright bober stops, I think you can get them at wally world

Originally Posted by "G"

I like the football shaped rubber ones from BPS....the go thru the rod guides good without hanging up on them....they have a wire loop thru them....just run your line thru the loop and pull the bobber stop off the wire and its on your line, throw the wire away. Been using them for years....to adjust lust slide the bobber stop up or down your line.

I have used many kinds and love this one.....it is so easy to put on.....the trick is, after you get it on, make sure your line is wet before sliding it.....I also put one on my rods that I tight line with just in case I want to switch to a bobber quickly....

also, when installing it, you will get a small kink in your line, usually about 6" from the end.....I just cut that off to avoid having a weak spot....