Thread: Problem solvers needed

How about some bracing on that console ? Might consider coating the gunnel to the floor with some type of liner. I painted the interior of my Jon boat with a product called Grizzly Grip ( it's a non skid product) but it's kinda thick and definitely took some of the noise/vibration out of it too. If you go that route, go for the thicker/more viscous product. The thin stuff they sale may not help you that much.

You also could look at putting a piece of that board insulation between the console and the wall of the boat. That would probably be the cheapest.

Agree with bracing the console, another cheap thought would be to get some of the window seal foam from Lowes, it comes in a roll, and try to pull the tape off of it, and push it between the console and the gunnel with a screwdriver. Might offer a little vibration dampening, have to put it in there and find out.

Could you brace front and back then release it from the outside wall, assuming the vibration is from the wall and not the floor.
if it's bolted to the side I'd remove the bolts , install some insulation between the wall and console to try to find the source of the vibration
A test might be to clamp a cup of water to the side rail and place one on the floor, drive the boat to see which shows the most action.
Just blue skying ideas

Thanks for the suggestions. Trying to use the gunnel is an interesting idea. I'm not even sure how it's attached, but, probably rivets. My gut feel is that to stabilize the gunnel to the deck would take some type of formed metal to do any good. Will give it some thought. It would be nice to stabilize the console all together.

Check for vibration isolation mounts, grainger, or Msc direct.

My first thought is pipe insulation between the gunnel and the console. Might could also put a layer of insulation/foam under the mounting bracket of the fish finder to the console, may help to dampen the vibration also.
Mike

Take a kid outdoors!

Pull away from wall creating a tension. Spray expanding foam underneath, front and back in all the cracks. Trim excess.

May not help, but you can buy vibration mounts on ebay for less than $10 for 4. You could try them under the items mounted to the console. If you bought a ram mount and mounted the finder directly to the rail beside you where the throttle is, would the position be ok. It may not vibrate as much as the console due to it's rigidity.