Fatman it depends if I get some more soft aluminum. Working on the blank for the shad darter. I do have the blank for the 1/24 oz. So that part is up in the air. Need to finish the shad darter before I start any thing else.

NP I would use those in my wood router but not in the drill press or the Mill. Those are too course for metal work. You need much finer cutter for work in metal. Some may disagree but I like the fine cutters in aluminum with lots of cutting fluid. To give you a idea I buy most of my cutters at the same places that I buy my jewelry repair tools. But I don't like a lot of clean up and polish on the molds. One of the reasons that I like to press a slug in the mold it polishes as it is pressed. Some even leave tool marks in the cavities where mine are very smooth and are very easy to release I don't have to smoke or spray them they will fall out of the mold.

Redman