Reply With QuoteIs the shear pin bent? If so that will cause the vibration.
Likes: 0
Thanks: 0
HaHa: 0
Crappie Wall Hanger II
Terrova worries?
Ive had my new Terrove about a month now. Last weekend while trolling slow I bumped the blade on a limb under the water. It started vibrating bad!!! I lifted it out of water and ran it. It seemed smooth. It quit vibrating. Done the same thing today. This time it took about 10 minutes to get it to settle back down. No warped shaft. Any ideas?
Crappie.com 2K Star General
Is the shear pin bent? If so that will cause the vibration.
Arkie lures prostaff
Spyder Loc rod holders
Slab Shaker rods
Proud member Team Watch the Finger
Crappie Wall Hanger II
I will check that. The part that I don't understand is, the vibration goes away after I lift it out of water a couple times and reset it n water.
Crappie Wall Hanger
It could be doing it only while under load from water resistance.
Crappie Wall Hanger II
Mine did the same way.Run it a few seconds,turn off,back on a few seconds,always went away.After a few cycles this way fine shape.
CATCH FILLET
Crappie Wall Hanger II
That's how I get it to stop. I've check pin and shaft there straight. Only thing I can find is some play n shaft in and out. No up and down.
