Quote Originally Posted by Don G View Post
OK, I have found something new by reading the manual again...:D

The pictures above are once again in the 200khz beam, Switchfire Max Mode & sens on 17..

I found out that you can set the 83khz sensitive setting without affecting the 17 setting on the 200khz beam.. My 83khz setting is 0 now which is the factory default...

The next time out I will set the beam setting at 200/83, the switchfire to Clear Mode and increase the 83khz setting from 0 to +10 in steps to see if this helps....It is strange that the 83khz sens setting is from -10 to +10 with 0 in the center which is factory default..The 200khz setting is from 0 to 20..

I sure hope this helps..

Alan, I will also try the other color palets to see if this helps..
Not sure color will help?? What did you do to get the jig showing so big?? Even when I zoom in it don't look that big