Reply With QuoteIt would look like this bait but with out the brown side. This is taken from dr nip as an example
Likes: 0
Thanks: 0
HaHa: 0
Crappie.com Legend
Question on injecting
Ok I have issues with my mold only when placing tails in the mold and injecting the bodies. Only on the left side bottom two cavities do I have issues with. The body will only fill half way just like I was laminating. The result is a tail with only half a body down the middle. I have tried worm oil and sometimes it works and then not. The mold is warm. Any ideas. It is a mo magic mold. I sure wish they would come out with a tail mold.
Crappie.com Legend
It would look like this bait but with out the brown side. This is taken from dr nip as an example
Crappie.com 1K Star General
When your injecting its probably pressure on your clamp. When it's too tight no way for air to escape ? Causing voids
A Proud member of Lake Allatoona and Lake Weiss (Team Geezer)
Crappie.com Legend
Question on injecting
Makes sense as that is where my clamp is on that side. Thanks will try a lighter clamp pressure. I have been clamping it pretty good. I would know when it didn't fill good as I would see air bubbles come up the spru. That must be from the air not vented.
I guess my question would be do the molds only require one clamp on the open side?
Last edited by arkansasbowhunter; 05-12-2015 at 08:16 PM.
Crappie.com 1K Star General
If you're doing half a bait in one color, make sure the side open for injecting is the side with the vents cut into it.
Crappie.com Legend
