Thread: using Jacobs old molds with small porthole here is a adapter.

Rick should make up a few more of his adapters. A couple years ago he said he wasnt going to make any more so i bought 2 of them in case i lost mine! I use it with a blending block no problem.

Originally Posted by RonDon

Rick should make up a few more of his adapters. A couple years ago he said he wasnt going to make any more so i bought 2 of them in case i lost mine! I use it with a blending block no problem.

The one that I made up works fine with the blending block but you'll have to cut the galvanized fitting down so the blending block will set on top don't recommend it it is a balancing act and I don't want anybody to get hurt so the original blending block that I posted works fine we used a dual injector today on a cut down version of my blending block it did do quite well but a little tricky you would cut the thread it in other galvanized fitting down passwords threaded cut it off and be careful if you do this it is a little bit of a balancing act with the blending block sitting on top of the reducer I only recommend again the one I posted here yes Rick should make up a few more of them or on his molds he's making now he has a bigger porthole but a blending block does not set properly on it so most of the ones that I buy I reamed them out so the blending block will fit in his newer molds.