With the refrigerator pushed back it is time to install the Boiler Over-temp Safety Device. If I had one of these installed to begin with I would not have had a Cooling Unit failure.

Name: Installing ARPRV Refrigerator Boiler Device.jpg Views: 96 Size: 59.8 KB

Here is the wiring schematic. Its pretty straight forward, the bulb on the boiler senses the temperature and cuts power to the fridge if too high a reading is present.

Name: Reconnecting Refrigerator.jpg Views: 99 Size: 73.6 KB

Since I added quite a bit of add-ons to the refrigerator they all needed power supplied. The new Blower fan for the Cooling fins didn't have a fuse so I added one again for safety. All the slack in the wiring was policed up, propane connections here and the Hot Water Heater were tested for leaks, and the ARPRV Controller installed.

Name: ARPRV Controller Mounts on PCB Cover.jpg Views: 99 Size: 69.2 KB

The controller mounts to the Printed Circuit Board cover. It was kinda late by this point yesterday so I will fire up the refrigerator today sometime.