Quote Originally Posted by dannypeoples View Post
Sorry to hear of your misadventure. I have also set one of my JDM blanks on fire. Luckily it was the tip so I cut it off after it broke. Pains other ways.


Sent from my iPhone using Crappie.com
I’m considering repairing the rod section . It’s in the top half of the middle section of a three piece. I was planning on putting a spinning back in that spot anyways.
Just a little worried about having a flat spot in the bend .
Think I’ll make the repair and check the bend before finishing the rod .
Hate to just toss it out.