transducer mounting plate
Hey all, I just mounted my SI transducer and I think it went well, but I hated putting holes in aluminum boat. I have found a little water in back of boat, usually bone dry. I dont know if its from the bait cooler I had splashing around in there last week, or something new as today was first day on water since installation.
I was wondering about redoing the whole thing taking all screws out, putting sealant on it and then mounting a plate over that. Buit I dont know what size to get or thickness?? Just never seen one put on and scared that the screws to hold transducer may not have enough "bite" to hold it on.
Just getting yalls opinions, and thanks
Tom