Thread: problem pouring sickle hooks

I agree pouring one at a time does get old!!
The only time I have trouble w barbs or collars is when my mold is to cold, or lead is not hot enough, pour about 3 times and the rest will be perfect, for me.

Yeah that's what I thought but I can go from pouring regular eagle claw 570 hooks just fine and then switch to sickle hooks and it messes up, black hooks seem to be worse than just bronze

What sickles? Matzuo? They have heavier wire than the ec hooks and this can create some issues in a mold that already needs to be done hot. I had a hilts years back and ran into casting headaches with it and sent it to the garbage. You should try the Eagle Claw lil nasty sickles. They're a great hook all around.

I use the matzuo, and some I get from Crazy Angler, sickle hooks is all I use.

They are matzuo, I really like hooks, I will look into the ec sickle hooks thanks. Like I said they come out perfect in my hilts mold, I haven't ever actually used sickle hooks so maybe I will just stick with regular hooks, I've never had a problem with them. Thanks for all your help.

I cast some Marzuo black sickle hooks, I had to get the mold hot for good ones.

Have used the red and black in ball, minnow, pony and tube and never had a problem. Just preheat the mold by pouring without hooks and they pour right up. I also have the Eagle Claw sickles.

I have had trouble with the sickle hooks and when I miked them the hooks are a little bigger. The hook is closing the venting or out gassing. I usually run into this also using larger hook sizes. If you really want to shoot these hooks you will need to open up the hole at the bottom just a little or like I did was vent it out to the side. Try tilting the mold at different angles while pouring but be very careful. Some molds are just a little tight. I have trouble with the light wire hooks going past the margins and may have to trim them. They are a lot smaller in diameter than most hooks. Like the others have said a hot mold will shoot a lot different than a cool one. You can also force inject it by putting the nozzle into the mold fill hole. Again,please be careful with hot lead experimenting. I am assuming you are using a lead pot???