Thread: Using artificial lures/baits

Originally Posted by mquast200

Northern Michigan huh? Just about where at? I grew up In The area but now I'm a southerner lol. Grew up outside traverse city, manistee, scottsville and ludington. Anyways I would love to learn your bobber technique. Basically what I do now is make a 3-5 second 12 o'clock turn. It works sometimes but I just have this feeling it isn't the best practice. Nobody I know jigs so I'm learning everything for the first time.

I was raised in Grayling and spent the majority my life, 51 years, fishing all around Northern Michigan, with most of it being in the Grayling,Gaylord, Kalkaska, Roscommon, and Gladwin areas. When fishing jigs under bobbers, I always start high in the water column and work my way down. If I am fishing in 10 feet of clear water, I will set my jig 1 foot under the bobber to start. I'll cast it out and just let it sit for a couple minutes, without any motion at all. If nothing bites, I'll just shake my rod a bit until the bobber wiggles a bit, imparting just a little motion to the jig. I'll do that for a couple seconds and then let it sit again. Now if I get hit, then I'll continue that presentation, casting from an 8:00 to a 4:00 position around me until no more action. If I don't get a bite with the initial still/twitch presentation I will slowly reel my bobber about five or six feet. Sometimes this is when it gets hit and lets me know that they are high in the water and active. Once again, if it does not get hit, I will stop it for another minute or two and then repeat the same twitch, sit, move. I will use that presentation in several casts around me until the bites are done or I did not get any bites. If I did not get any bites, then I will lower the bait a foot or two and repeat the entire process until I have lowered my jig to within about a foot of the bottom. For the most part, I am fishing areas that I am confident of fish being present, so if I did the entire round of bobber/still/twitch, and had little or no action, I will raise the jig back up to about two feet from the bobber, cast it as far as possible, and then once the jig has settled under the bobber, I will steadily reel it in until it is back at the kayak, completing the same routine of lowering the jig, and, or, changing retrieval speed, until I have found the fish, or am convinced that they are not going to bite on a bobber rig. Then, before I move, I will grab my rod that is rigged with a jig and no bobber. My bobberless presentation is almost always a cast and retrieve method, starting at a foot or so under the surface, just like bobber fishing. Keep in mind that the attitude of the fish will often change, just like ours, so what works one day, or even one hour, might not work the next. Two different rigs always ready to go, and a willingness to put in the time, especially if you are pretty sure you are on fish, is extremely important to me, and probably my greatest asset when it comes to catching panfish. I have no problem sitting on a spot for 30 minutes to an hour if I am sure there are fish. Of all the jig presentations I use, the cast and steady retrieve is definitely my favorite other than right after ice out, the spawn, and just before freeze up, during which times I will use the bobber and jig rig. If you can find those little clear bobbers I show, definitely purchase them. I am a firm believer using rigs with clear bobbers usually catches more fish than the colored stick bobbers or round colored bobbers. Of course there are situations where it just doesn't matter, but to me, it's the clear bobbers or none. Here in Northern Michigan, many of the lakes, and other waterways are extremely clear, which is the main reason I started using the clear bobbers many years ago. I grew up fishing some of the best trout lakes, streams, and rivers in the country, and they are very, very clear. My grandfather taught me when I was quite young, that you could use a clear bobber with various flies, live baits, and lures, and could get a good cast without spooking the trout. Well as I got a bit older, and my passion for crappie and bluegills grew, it didn't take long to realize that if it could trick a trout then the clear bobber rig could definitely trick a panfish, so I incorporated the clear bobber trick into my panfishing arsenal. I hope this helps you out a bit more. Good luck.