Replacing fuel line on outboard, need help

[maachuu]

please if you dont mind, look at this post on the mechanic board and see what I am doing wrong


thanks

maachuu

http://www.crappie.com/crappie/mecha...ml#post1478446

[satdoc1]

Check blub for flow direction.

[maachuu]

Check blub for flow direction.

arrow on bulb pointed towards connection to motor

[DonDon]

Thinking I'm about to have to replace mine. It's starting to get alot worse on cutting out and running rough

[yikess]

Try and shoot some fuel out using the bulb while it's disconnected from the engine to see if fuel is going the right direction regardless of what the arrow says.

[satdoc1]

May have to Push in the little ball on the engine fitting with a screw driver to allow the flow.

[Cray]

If you have quick connects on ends of hose, Check end that goes on fuel connection for a oring seal in front of check ball. I have had those roll out of place on new hoses when first installed letting it suck air. hook to tank remove quick connect from motor end and pump to see if you get any gas out but suspect it has something to do with connection at tank since 2 hoses did same thing. Could be slight difference in old and new connectors. Also might put old connector on new hose. Hope you get her straightened out.

[Wannabe...]

I'm just so proud of you fellers. Ya'll have been paying attention in class haven't you.

Wannabe...

[satdoc1]

Pppppppffffffffffffffffffffffffffffffffffffffttttt ttttttttttttttttttttttttttttttttttttt!!!!!!!!!!!!! !!!!!!!!!!!!

[maachuu]

thanks guys, I got it to prime up a couple of times but it wont stay up, will check the o-rings and then see if I can get fuel to come out the end that is connected to motor



thanks

maachuu