Pretty much the same as I use ... but, I built a PVC "L" shaped holder that slips over the seat pole. I drilled thru the upright PVC pipe and the bottom pole of the umbrella stand & put a cotter pin thru it, so the umbrella wouldn't blow out. Works well and can be moved around the seat to better position the umbrella vs Sun angle. The only problem I've had with the umbrella has been during heavy winds (>15mph), which turned the front half of the umbrella "inside out"... but is easily pulled back into place, and hasn't caused any noticeable damage to the umbrella.
I've used it when casting and when using my 14' rods ... and haven't found it to be "in the way" enough to warrant not using it when the situation calls for one.


Likes:
Thanks:
HaHa: 



... but is easily pulled back into place, and hasn't caused any noticeable damage to the umbrella.
Reply With Quote
















