Well ya'll did it...you got me back in here to see what the heck was going on. I have been getting PM after PM about the Jig Tying Case. I can see now that the old post found its way back to the top of the pack.:D

You are right I didnt really think that folks were that serious about buying the Jig case. No-one scared me away, I just never took the idea and run with it. I am not even sure where to start as far as setting a price. I did spend much time on the project but now that I have the general pattern and layout, it would be simple enough to get a few of these made up and ready to go, and it wouldnt take near the time it took to come up with the original idea.

Give me feedback on what you think would be a good starting price or what you feel would be a fair price that you would be willing to pay for a case like these. I will get a cost on materials and time and see how that works out in comparison. It may be that I can make a run on these and see how they sell and if it would be profitable.

If I see that this works out.....here is what I have in mind. I will build a said number of theses Jig Tying Case's as a test run. Once finished I could post pics of the identical case's and price. For those of you who have inquired about the Jig tying Case, I will give you first opportunity on the purchase if you so wish. These Jig tying Case's will all be as identical as possible. Also my design is formed around the AA Vise. This vise is inexpensive at only $11.95 plus shipping from the supplier I used. This will be included in these first run Jig cases. If all goes well and the idea is accepted and well liked then we could go from there as far as adapting other style Vise into this Case.

What Ya'll think?

Comments and suggestions? My email is [email protected] or just PM me!
Also feel free to call my cell 1-318-533-9259, please leave me a voice mail and I will return your call.

Again THANKYOU ALL for the wonderful comments on my work!:D