Glen

If you recall when we received these we had a tournament that weekend. When I installed it I spent about 3 hours filing and sanding the center pin so it would fit into the seat base I then spent another couple hours filing and sanding the seat mount so I could insert my power pedestal into the seat base. Whenever I remove the dual seat mount so I can go back to a single seat it takes a couple hours. I have to place my power pedestal in a vice and beat the seat base off with a dead blow mallet, then I bolt a piece of unistrut to the center pin and pry it out. The center pin has my seat base fouled up and I had to remove it last night so I could get the pedestal out for reinstallation of the double seat mount for this weekend. I probably should have sent the whole thing back to Terry, but with the tournaments we were having I didn't want to be without the dual front seat, my mistake. Anyway I'm fed up with it and am looking to replace it along with a new pedestal base. The rod holders from Terry are fine but I would never recommend him for a dual seat mount. Anyway I'll be looking at different setups and decide what I'm going to change to this winter.