Reverse on Trolling Motor

**ifish** · 02-04-2008, 08:47 PM

Thanks Tom for all that you have done on the TM reverse . I will gather the parts and wire them in and see what happens. Hope you don't get any wind damage Tuesday. *them trees a Mess to cleanup*

**Barnacle Bill** · 02-04-2008, 09:08 PM

Originally Posted by Cane Pole

This simple circuit will work. The Bosch relay is capable of switching 50 amps. It is not a sealed relay. After you get the relays wired, seal the bottom of the relays with marine silicone.

Large Red and Black wire use same wires as TM wiring. Other wiring is relay control. 18 gage wire will work ok here as this is a low current application. Mount the toggle switch where you wish.

Disclaimer: I am not responsible for anyones wiring, installation, damage, etc. This is a free circuit. Your choice to use or not use.

Do not use a plastic box for these components. Use metal if you use a component box. This circuit NOT for electronic control TM.

link to suggested relay. Be sure to check the relay pin numbers (schematic vs diagram on relay).

http://www.tessco.com/products/displ...id=google_base

Tom

Looks good Tom. I saved your schematic for future reference. Now all I got to do is remember I have it. :rolleyes:

**Cane Pole** · 02-04-2008, 09:19 PM

Originally Posted by IBNFSHN

Looks good Tom. I saved your schematic for future reference. Now all I got to do is remember I have it. :rolleyes:

I have that remember problem. I also got too many "new folders" inside "new folders". haha

Thread: Reverse on Trolling Motor

Thread Tools

Display

Posting Permissions