When in dual pane view, map and 360 view, how do I get the 360 view front view? I am able to get front view in 360 only view, but can’t find option in dual pane view.

Next is interference. My picture is clear in 360 view but when I have trolling motor on the picture seems washed out with sometimes the intermost circle is showing some detail. I can not tell you if I have interference with side imaging or down imaging as I was just dealing with the 360 on my last outing.
Trolling motor is 12 v motorguide Xi5. I have 2 ferrite clamp-on on the motor’s power cord. The wire from the battery (located in battery compartment in front of boat) to TM are on left side of boat.
My transducer, mega 360 transducer are mounted on a da ducer apparatus on right side of boat. Power to the hb units and the mega 360 are each on their own duplex wire run from a fuse box mounted next to the cranking battery in the rear right side of boat. The HB units both have the power cord with preinstalled chokes on them.
I have a ground wire from the trolling motor battery negative post to cranking battery negative post running down from front to rear on left side of boat.
I do have a on board battery charger with the leads to the cranking battery going down the left side of the boat.
So the next time I am on the water, I will try to disconnect the lead from on board charger to the cranking battery to see if that has any effect. I did write to the rep from dual pro and they told me that on-board charger can’t create rf interference. Maybe I was not asking the right question though. So if that wire is the antenna for the interference, do you use ferrite rings on that cable or do you just need to get a separate charger for that battery?
So where do I start? I have ordered more clamp on ferrite chokes and some ferrite rings.
Also if it makes difference I have a fisher 1754 Aluminum boat.