Thread: Transducer on Terrova

After ripping the cable out of one I used the Cornfield Crappie Cable Saver. Well worth the money. Give Mark a call. Great customer service.

Cable save'R add transducer to a 2018 And Newer Terrova Motor | cornfieldcrappiegear





Sent from my iPhone using Crappie.com

I removed the head from the trolling motor shaft and disconnected the wires...slid the shaft out of the bracket...mounted my transducer to the motor at bottom of shaft...then used clear silicone caulking to glue the transducer wire down in the groove in the shaft....then slid the shaft back in the bracket and connected TM wires and put the head back on...put a zip tie around the wire and shaft top and bottom. It sounds tricky and difficult but its really not.

What transducer .... I put my old HDSI transducer in the shaft slot but most of the newer transducer cable are too large to fit.

Originally Posted by brjohnson429

After ripping the cable out of one I used the Cornfield Crappie Cable Saver. Well worth the money. Give Mark a call. Great customer service.

Cable save'R add transducer to a 2018 And Newer Terrova Motor | cornfieldcrappiegear





Sent from my iPhone using Crappie.com

X2


Sent from my iPad using Crappie.com Fishing mobile app

What model is your Terrova? Mine was a 2018 model and had the spring assist so I couldn’t do mine like G talked about without taking the spring assist off. If yours is an older model, there is a Cornfield Cable Saver for an older version in the personal classifieds.


Sent from my iPhone using Crappie.com

I put my Trasducer cable inside a 1/4" clear plastic water tubing by sliting one side of the tubing. Does a real good job of protecting the cable. Zip tie to motor and shaft, zip tie across head on shaft looped around locking pen both ends, leave slack for motor to turn, then zip tie cable to shaft above the deepth locking nut. Works and does not cost $140.00.

I used the cornfield crappie mount for my Terrova and it worked good

On my old Terrova I did what G said and it worked great. I just mounted a brand new Terrova and used a Cornfield Crappie transducer saver because I didn't want to take a chance of voiding the warranty.