Thread: New Terrova

Is that good or bad? Anything I need to do?

Boat scale. Start at 0
Adjust up or down depending on boat weight and wind.
Neg. number is a slower reaction by motor
Pos. number is a faster reaction by motor.


Decrease the offset number.

1st make sure you are using the screws supplied by manuf.

Loosen the screws and slide a piece of duct tape under the front edge from left to right.

Make a pencil mark on the puck and the tape.

Tighten 1 screw and remove the 2nd screw.

Test if you can move the puck with some effort. You don't want the puck too loose or it may move by itself.

Move the puck a few degrees left or right. Rerun calibration.

If the offset is larger, wrong way.

If the offset decreases, this is correct direction and keep adjusting until you get about 5 degrees offset and press set button and mark the tape with the pencil.
This is the new puck location.

Tmotor is now calibrated to forward boat direction.

Redrill second hole and reinstall 2nd screw.

If the 1st hole for the 2nd screw is too close to the new location, start over with a new location but don't drill the 2nd hole until calibrated.