Thread: Obviously can’t read

Try this Settings>System> Display>Color Mode or push your on/off button color mode should come on screen

Thanks anyway. Not the choices available. Appreciate your time.


Sent from my iPad using Crappie.com Fishing mobile app

I have the 93sv plus unit so it is proably different. When I turned my unit on I had to put it in sonar simulator in order to get to the right menu. I then was on the Livescope simulator page, pressed menu, sonar setup, appearance, and then color screen. From here I was able to change to about a dozen diffrent color schemes but I really prefer the amber and blue. Hope this helps.

Originally Posted by Roy

I have the 93sv plus unit so it is proably different. When I turned my unit on I had to put it in sonar simulator in order to get to the right menu. I then was on the Livescope simulator page, pressed menu, sonar setup, appearance, and then color screen. From here I was able to change to about a dozen diffrent color schemes but I really prefer the amber and blue. Hope this helps.

I figure my model does not have those choices as I do not seem to have simulator mode. At least I can’t find it on start up or in the manual. Thanks again for trying to help.


Sent from my iPad using Crappie.com Fishing mobile app

Adjusting the Color Mode
Select Settings > System > Sounds and Display > Color Mode.
TIP: Select > Color Mode from any screen to access the color settings.
Select an option.


http://static.garmin.com/pumac/GPSMA...2_OM_EN-US.pdf

Page 12 of 72.

To change settings for a particular view, you will need to be in that view.....Livescope; 2D; Side imaging.

To get to Simulator.....Press Home Button; Select Settings; Select System; Select Simulator.. When finished, be sure to go back and turn the Sinmulator off.

To adjust color on LS, load Livescope, press the menu button; Select Sonar Setup; Select Appearance; Select Color Scheme.

Originally Posted by DOFC

To change settings for a particular view, you will need to be in that view.....Livescope; 2D; Side imaging.

To get to Simulator.....Press Home Button; Select Settings; Select System; Select Simulator.. When finished, be sure to go back and turn the Sinmulator off.

To adjust color on LS, load Livescope, press the menu button; Select Sonar Setup; Select Appearance; Select Color Scheme.

These instructions are for the 1022 that isn't touch screen. Hopefully it will help on the XSV model

Did not work on land. Will try again tomorrow on the water.


Sent from my iPad using Crappie.com Fishing mobile app