Thread: A Question About Helix 9/10 Units

Change "User Mode" under the Setup tab to "Advanced" to have access to all menus ...

User mode in "Normal" hides some options ...

Digital readouts are default at "Overlay" which only shows depth, speed, and water temp (depth, speed, and COG in Chart Views) ...

To get other digital data options in Sonar views (not Chart Views nor Chart combo views) ... :

*Press Menu twice to get into the Main Menu System ...
*Cursor over to the Setup tab ...
*Cursor down to Digital Readouts ...
*Cursor right or left To select "Boxes" ...
*Press Exit to get back into the Setup tab options ...
*Cursor down to *Select Readouts" ...
*Choose the data options desired in each readout box ...
-----

To get other digital data options in Chart Views And Chart combo views ... :

*Press Menu twice to get into the Main Menu System ...
*Cursor over to the Setup tab ...
*Cursor down to Digital Readouts ...
*Cursor right or left To select "Boxes" ...
*Press Exit to get back into the Setup tab options ...
*Cursor down to *Select Nav Readouts" ...
*Choose the data options desired in each readout box ...

Note 1: Some readout boxes in Chart Views are hard coded and cannot be changed (dependent on software version) ...

Note 2: Temp will not be available in the choices unless the above procedure is performed in Normal operation ... because the unit cannot detect the temp probe is connected (in Simulator) ...

Rickie