Thread: Bow Mount 360

Bear in mind this is a work in progress and not finalized. But all I did was get Scott of HiTek to weld a 1 1/4" OD aluminum tube to one of his bases. Then just made a Short U-shaped mount out of 1 1/4" PVC. I had to wrap the PVC once with rubber to get a snug fit with the clamp of the 360. So simple, even an electrical-type could do it.

I have a longer piece that allows it to sit in front of the trolling motor. It works well at trolling speeds but wobbles a bit when I'm going 3-5 mph.

Both the longer tube and the shorter tube can be attached without lifting the trolling motor.