Thread: 798 Loading message

CF,
Answered this on the other forum you posted this on:
The “not enough memory” message pertains to the unit’s memory and not the SD memory card that you used. From what I have been hearing; the waypoints load anyways so this may just be a bug in the software. Of course in those instances they did not also get the “No new Nav Data Found” message.

Where did this Nav Data come from? HumminbirdPC or some other source?

thanks for the reply HBG. I marked most of the way points on Humviewer. Then transfered them over to HumminbirdPC. I had earlier on had a recording on the card but took it off and stored on HBPC. I was trying to see if that would make a difference but it did not. All that is on there now is the waypoints. Everything was loading fine. Have not had any problems. I just keep getting the message. Is this going to be a problem if it continues? I have not updated My unit yet since I got it. Will the software update help with this? I figured I would update it after I got everything like I need it and have learned how to use everything and then update it. Trying to take it step by step and not over complicate things.CF

Originally Posted by Humminbird_Greg

CF,
Answered this on the other forum you posted this on:
The “not enough memory” message pertains to the unit’s memory and not the SD memory card that you used. From what I have been hearing; the waypoints load anyways so this may just be a bug in the software. Of course in those instances they did not also get the “No new Nav Data Found” message.

Where did this Nav Data come from? HumminbirdPC or some other source?

I answered on the other forum too HBG. need to make it more clear. It is loading everything from the SD card onto the unit fine. Just keep getting the message. It shows XX number waypoints loaded just like You have described along with the memory message. If this is a software bug, is it anything to be concerned with? Thanks.CF

CF,
I have not officially heard that it is a software bug but think it is. Therefore it should get fixed in a future software release. I don’t think that there is anything to be concerned about as long as the waypoints load into the unit.