Just connect to positive and negative of either battery that you want to and you will have 12 volts.
Likes: 0
Thanks: 0
HaHa: 0
TM on the system, what do I need to do to cut it back to 12v ? Im guessing something back at the batteries but not sure what it might be
thanks
maachuu
Just connect to positive and negative of either battery that you want to and you will have 12 volts.
I have spent most my life fishing........the rest I wasted.
PROUD MEMBER OF TEAM GEEZER
PICO Lures Field Rep
![]()
Or if you are going to use a 12 volt TM and want to take advantage of both battery's then wire your batteries in paralell .....that will give you 12 volts.....when they are wired in series its 24 volts.
I have spent most my life fishing........the rest I wasted.
PROUD MEMBER OF TEAM GEEZER
PICO Lures Field Rep
![]()
It depends on the wire harness but in general you would connect pos 1 and neg 1 directly to the motor. Then you run a jumper from pos 2 to pos 1 and a jumper from neg 2 to neg 1. If you have a 12/24 plug you can open up the plug and change the wire connections in the plug to get the same results.
I have spent most my life fishing........the rest I wasted.
PROUD MEMBER OF TEAM GEEZER
PICO Lures Field Rep
![]()
Wire your two batteries with together with jumpers positive to positive and negative to negative...then connect your TM wires to one of the batteries....thats Paralell. This will give you 12 volts.
I have spent most my life fishing........the rest I wasted.
PROUD MEMBER OF TEAM GEEZER
PICO Lures Field Rep
![]()
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va