Thread: Mold dimensions

Does anyone have the Small fry mold 12 cavity from Do-it molds that can share the dimensions of the flat sides with me? Don't need the mold thickness, just the side measurements. I looked on the do-it site but the mold dimensions are not shared. Thank you in advance. Eric, aka, Jamesdean.

I guess, I'll just go ahead and buy it on first, then get the measurements. Was hoping to get a jump ahead by ordering the thin aluminum for a dividing plate, as it's not Available in my local store...

Originally Posted by Jamesdean

I guess, I'll just go ahead and buy it on first, then get the measurements. Was hoping to get a jump ahead by ordering the thin aluminum for a dividing plate, as it's not Available in my local store...

Are you talking about thin aluminum to make a laminate plate? If so why not get some roofing flashing & make it?

See, I didn't think about roof flashing. Hadn't really crossed my mind. Thank you Les. I will look into it.

We have used metal fleshing in the past many times we used it so we can do a laminate until we got a dual injector.

Originally Posted by snake River

We have used metal fleshing in the past many times we used it so we can do a laminate until we got a dual injector.

Thank you for telling me about the metal flashing stuff. For some reason I had in my head it was much thicker than what I found today at Lowes. I bought a couple of the 8"l x 4"x 4" 90 degree piece. This way I'll have extra if I mess one up in the process. This is thin enough to cut with some stought scissors. Thank you again.

And we'd need to know which small fry you're referring to: 1.75", 2.25" or 2.50".

Originally Posted by CTom

And we'd need to know which small fry you're referring to: 1.75", 2.25" or 2.50".

Yes, I recon that would help ...It's the 1.75 CTom. Thank you for Pointing out my lapse...

Originally Posted by Jamesdean

Yes, I recon that would help ...It's the 1.75 CTom. Thank you for Pointing out my lapse...

Do-It makes a nice lamination plate for that mold. $22 + shipping.

Originally Posted by CTom

Do-It makes a nice lamination plate for that mold. $22 + shipping.

Thank you CTOM for the info. I'll see what I can do to get me one on the next order.