Sure quiet on here again.

Quote:

---

Originally Posted by roostertail3427

It has less its not completly smokeless and the plastic is just a tad harder it seems like without affecting the action I prefer it to 212 just cause 212 is a little soft and it's really smokey but that being said I still got 3 gallons of it that's has to be used lol

---

I just got 10 gallons of the 212 I will definitely try the other one out probably will switch over if it's not as bad on the smoke.

Quote:

---

Originally Posted by trypman1

I am sitting here looking at my last order from you, Maybe soon I can/will try them out. I don't fish under 40degrees.

---

I'd rather be fishing when it's 70 to 80°

Here is another little stinger should be good for ice fishing this mold is from fat guys fishing .875'' LITTLE BEN.
Attachment 390889

That's a cool mold Bob just received my stingers from them they make some of the best molds especially like how the sprues are smallest u can make themAttachment 390916

Quote:

---

Originally Posted by roostertail3427

That's a cool mold Bob just received my stingers from them they make some of the best molds especially like how the sprues are smallest u can make themAttachment 390916

---

I have two of their 2 inch stingers that mold is awesome Have you seen my post on doing a Core shot with that mold.
Attachment 390932

No I havnt where is it located

Quote:

---

Originally Posted by roostertail3427

No I havnt where is it located

---

on https://www.crappie.com/crappie/diy-...342-core-shot/
The pin size on the stinger will be different I believe I used a finishing nail I will try to post a picture here later on that stinger.

Quote:

---

Originally Posted by snake River

Here is another little stinger should be good for ice fishing this mold is from fat guys fishing .875'' LITTLE BEN.
Attachment 390889

---

What size jig head is that Bob?

Quote:

---

Originally Posted by MCG1

What size jig head is that Bob?

---

1/80oz. You could probably go down Smaller

Quote:

---

Originally Posted by snake River

on https://www.crappie.com/crappie/diy-...342-core-shot/
The pin size on the stinger will be different I believe I used a finishing nail I will try to post a picture here later on that stinger.

---

Here is a picture with the stingers you'll see the finishing nails across the cavities put your mold back together and shoot it pull it apart take the pain out of the bodies cut the tail portion off and put the bodies back into the mold and shoot your core shot. Depending on the different molds they are the nail size might be different of course you cannot do this with all molds but there are quite a few of them that you can do this with just a lot of trial and error and of course this is very time consuming.
Attachment 390935