Question for condo makers

**pstone** · 10-21-2006, 11:15 PM

You are correct, and I thought about that also. It will be safe, I'm going to drop it in deep water anyway.

Originally Posted by haugboss

when u finish putting it together on the boat u have to bend the rebar over so the tubes dont come off
al

**pstone** · 10-21-2006, 11:16 PM

I thought about the all thread too, but the short peices of rebar are free, I pour concrete slabs for a living.

Originally Posted by crappie10

If you used all-thread, you could run a nut down on it until tight.
my other thought is, what would make it spin in the first place?

**Bait Eating** · 10-22-2006, 01:18 PM

Will it hurt anything if the pipe moves some?

**John Brower** · 10-22-2006, 03:57 PM

I understand what you are after, but i am not sure the pipe would spin that much, to be concerned about it. especially when the wind is calm enough to let you fish. The rebar thing could be dangerous and i'm sure you will put
the attractors out in deeper water.

just a thought
John Brower

**paw paw perch** · 10-22-2006, 04:14 PM

Originally Posted by painterfish

ya cement sounds good to me i know that stuff is strong but years under water woundnt bet the rent on it either

There are probably no less than hundred millon miles of pvc water pipe in this country that hold pressure. Do you really think the lake water is going to afect it? I don't think so. and it is the simpelest soloution to his problem

**painterfish** · 10-22-2006, 04:55 PM

ya but there interlocked into each other makes a differnce i would think

Thread: Question for condo makers

Thread Tools

Display

Posting Permissions