Debated whether to just go with the transducer on the transom which works well with the 2 sonars networked but ended up deciding to try a second side imaging on the trolling motor. Way back in the day, an Arkansas member (lovin fishin I think) came up with a way to route the transducer cable through the slot in the terrova shaft. This is a selling point for the Terrova and the Humminbird units since the cable on the Lowrance is too big and the powerdrive doesn't have the slotted shaft. All you gotta do is just disassemble, route the cable and reassemble. The instructions are actually in the electronics forum. I do not glue the cable in the shaft. Strategic use of tape and zip ties will cause gluing the cable to not be necessary. This is complete except for routing the sonar end of the cable. I will not do this until I check the operation of the transducer. If it works ok, I'll drill an additonal hole in the switch panel and route the cable under the deck to the 998.
Attachment 133897
Attachment 133898Attachment 133899
RCC's Crappie Eradication Service
Eliminating your slab problems one fish at a time
For free estimates give us a call at O U 812.
Likes: 
Thanks: 
HaHa: 
Reply With Quote
