Likes Likes:  0
Thanks Thanks:  0
HaHa HaHa:  0
Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: My baot motor

  1. #11
    Join Date
    Feb 2008
    Location
    Greers Ferry
    Posts
    30
    Post Thanks / Like

    Default All fixed


    Thanks for the advice guys, I spent this morning with the motor in a bucket. I emptied a full can of gas 20.00 bucks worth if you know what I mean. I had water in my gas can from leaving the vent open. I also took some evinrude tune up cleaner and sprayed it in the carburator (follow the directions on the can) I was an amazing site to see what builds up inside an engine over time. I then let it sit for a few hours as recommended. then fired it back up then replaced the spark plugs. I mean it run better than it did when it was new. That spray was 7.00 and well worth it. I took it to the lake this afternoon and it run like a top. Once again thanks for all the advice. Now maybe I can get to do some good fishin
    Let's all go Fishin

  2. #12
    Join Date
    Dec 2007
    Location
    Washington NC
    Posts
    460
    Post Thanks / Like

    Default

    Dump a few ounces of Seafoam or other outboard fuel cleaner in the tank every once in awhile and you'll never have that trouble again!
    Three-fourths of the Earth's surface is water, and one-fourth is land. It is quite clear that the good Lord intended us to spend triple the amount of time fishing as taking care of the lawn. :rolleyes:

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

BACK TO TOP