When I called them last week looking for a powerhead. Hydro-Tec told me they had one for my Yamaha 250 hpdi. So I made an appointment for the following Tuesday. They told me to be there at 8:00am when they open.

Hydro-Tec was a great place to take my 2003 Yamaha 250 hpdi for a powerhead. Their shop was very clean and organized. The owners and employees were polite and on top of everything Yamaha! Wayne took me around and showed me what all they do. They have their own Dino testing, boring/honing, and machining shop. They also do custom lower unit work on Yamaha. They provide full service for Yamaha motors. They even have high performance parts for Yamaha. They will do some boring and honing on Mercury along with offering some high performance parts.
Great group of people at Hydro-Tec. By 2:00 that afternoon they had finished putting the powerhead in and going through the lower unit. They did the idol break in. They also went through the fuel system because when I bought the boat it had half a tank of fuel that had set for the last 3 years. They even drained the old fuel out for me. By the time I payed my bill I was out of there by 2:30 that afternoon.

I am now in the process of the 10 hour break-in. I had it out on the water running for about 2 hours. It sounds great and runs even better. Can’t wait to have it fully broke-in!

So far I am fully satisfied with my experience at
Hydro Tec Marine.

853 W Enterprise Lane
Nixa, MO 65714

Phone417)725-5746
Fax417)725-3046
[email protected]


Sent from my iPhone using Tapatalk