Thread: Commercial Chiller Service...Freon Charge tips

Home refrigerators rarely, and I mean rarely leak Freon. Now commercial equipment I think their leaking when they leave the factory. My Chiller was cycling very fast, temps higher than normal, and I can't hear the refrigerant as it passes thru the expansion valve so I knew it was low.



So anytime you're hooking up refrigerant to a piece of equipment to charge the system there is a very basic practice that Must be done in the correct order so air is not introduced to the system. Be it Planes, Trains, Automobiles, or a Chiller it all takes a charge the same. First you hook up your Gauges to the Low side Port on the equipment and the port on the refrigerant tank. At this point all hose connections should be tite.



So with the valves remaining closed on the Gauges you open the Charging Port on the equipment and the valve on the Tank. Here is the important part, where the tank hose connects to the gauges you crack the hose connection just enough to hear a little refrigerant escape. Just a little. Then tighten the hose back. Go to the Low side hose where it attaches to the gauges and crack it just enough to hear some refrigerant escape then tighten the hose back up. In that split second you hear the tiniest hiss the lines are purged of air. You must purge your hoses before charging. Todays Automotive Gauge sets have Low Loss Hoses. Unless your hoses have lost their pressure you do not have to purge.



So refrigerators working pressures is very low. Depending on air volume from the Evaporator fan motor the temperature dial for the refrigerant you're using may be less than you would expect. here my Chiller still works with 8 psi of 134A but we are at 40 degrees on the door.



Since the low operating pressures I charge at a low pressure.



Now at normal operating pressure (Less than 20 psi) the compressor shuts off at 34 degrees but the system bounces down to 32 degrees before warming up to cycle again. Just posting something different, I hope you find the information useful.

Certainly don't want to push air into the system