Thread: Ice jig forms ?

seen them on ebay

they are a lot smaller than the picture....

Originally Posted by riverrat8197

Hi guys new to the group was hoping someone could help me I'm looking for the silicone plates that hold the ice blades and hooks for soldering teardrop jigs Marmooskas and rocker Jake's couldn't find them in my searches online and was hoping someone had some information thanks in advance for any help

riverrat

LedHed's right as I have one purchased at a shop in Milw. WI which is around 2" in diameter

I now use a pair of bent Hemostat Curved Forceps costing less than $5
on Amazon or possibly WalMart may even have them

use a heat resistant surface (metal or aluminum plate) of some sort
set your blade down use the Hemostat on the hook adjust location as needed then solder as needed

Hope this helps

billygee :rolleyes:

back of the mold says;

Reinke Bros
1 414 383 5591

It's not silicone - harder material

LedHed

Yep! that's the one.

tried to purchase an ant mold from them last ice fishing season
Replied their supplier had past on and the molds were no longer available,
not sure if the one pictured is still available.

I finally made one out of the JB weld material, still holding strong.

billygee :rolleyes:

No wonder the molds aren't listed on the web site. Got the one I have awhile back. Too bad someone didn't pick it up - well made & a great idea.

Talked with bob reinke the owner of the company said he does make them just by special order not the same as the ones I am looking for which he said are no longer available so may have to get an engineer involved and figure out a way to get some made thanks guys for the help

What did you search for on eBay to find them been trying and cannot find any info

try ice lure materials, ice jig solder, and ice jig making

good luck finding stuff now considering the rarity.....

might have to take up bg on making your own