Thanks: 
HaHa: 
Reply With QuoteWant some type of organic vapor respirator. Cartridges only last like 12 hours or so I believe. I did a thread here in this forum on a cheap exhaust system that works wonders.
Keeper
Respirator mask?
Wondering if anyone had any tips for the correct mask needed when pouring plastic molds. I have a N95 but not sure if it is the correct one. Any suggestions would be helpful.
Ps this stuff is addicting
Sent from my iPhone using Tapatalk
Last edited by "D"; 01-12-2017 at 12:33 AM.
Crappie.com Legend
Want some type of organic vapor respirator. Cartridges only last like 12 hours or so I believe. I did a thread here in this forum on a cheap exhaust system that works wonders.
Crappie.com Legend - 2022 Crappie.com Man of the Year
I used the respirator mask that you find in the paint department of Lowes, Walmart, or any other good hardware store. Welcome from Alabama. Great job.
Here is another thread on ventilation that might help you some.
Mike
http://www.crappie.com/crappie/diy-s...1=#post2329498
Aquatic Species Removal Engineer.
May God be with you. Keep CALM and STAY ANCHORED with your faith.
snake River LIKED above post
Crappie.com Legend
Here is my thread on the fan. I have my jig baking oven right under it so that it gets my Pyrex cup full of plastic right under it. Only time my plastic isn't under it is when it's in the microwave or being poured in my injector.
http://www.crappie.com/crappie/diy-s...1659-vent-fan/
Crappie Wall Hanger II
In doing some research HazMat Classification B for personal protective equipment is for use with the plastic we all use. This means a SCBA respirator should be used at all times. These are way more expensive than any mentioned previously. Most start at $250 and go way up past $3000. Anyone use on of these?
