Thread: Homemade Rod Racks

Originally Posted by SeaRay

LOL I have two homemade rod holders on the back of my boat that use that flange. My holders are for when you fishing, not storing. I have an 18" pipe with angle iron welded at 90* across the top and a driftmaster holder on each side. I used the round plastic tightening knobs on the DM to replace the wing nut, (someone had posted that idea on here as well)

Attachment 151831

I really like those knobs for the holders, where'd you get 'em?

Nice Engineering

That looks slick...nice work!

Nice and neat job for sure. Looks like a pipe fitter did it.

Originally Posted by Speck

Those look great!! Good job!!

Originally Posted by SeaRay

QUOTE=lip_ripper;2591055]A black pipe floor flange with a 6 inch threaded nipple hand tight. So I can pull the pin, lift off the holders and unscrew the nipple and all that's left on the boat is just the floor flange.

LOL I have two homemade rod holders on the back of my boat that use that flange. My holders are for when you fishing, not storing. I have an 18" pipe with angle iron welded at 90* across the top and a driftmaster holder on each side. I used the round plastic tightening knobs on the DM to replace the wing nut, (someone had posted that idea on here as well)

Attachment 151831[[/QUOTE]

I'm in the process of changing out the bolts that come on the hi-teks with a knob and threaded stud, they only have 2 or 3 of the ones I need each time I go in to Westlake Ace Hardware. Works like a charm and one day I won't have to worry about having a wrench.

I sure like not having to use a wrench who the Tite-Lok Widow Makers. Dillon when ever you are ready you can design and fabricate me some transport racks for the Ranger. Dual console makes it tough to figure out a way to carry rods while on the water and off.

Put them to test yesterday, down the road and on the water. pulling the rods off and putting the back on took no time at all and nothing was tangled and the passenger still had plenty of room, and all my storage doors opened and was able to pull stuff out with no problems. While fishing I unpinned and pulled the front piece off and left the long center piece pinned to the back piece and let it rest on the floor, everything was out of the way while rigging. So far I am pleased with my low budget build.

looks like a heck of a deal , glad it worked out the way you planned.