Thanks: 
HaHa: 
Reply With Quotei use this site alot http://www.themarinedoctor.com/cgi-bin/YaBB.pl/YaBB.pl
Crappie.com 1K Star General
SEARS TED WILLIAMS 7.5 HP help please
Anyone know SEARS TED WILLIAMS 7.5 HP. OUTBOARD MOTOR - 21758881 .
I don't know if this is the right place to post this. Is there a forum where I can get info on sears motors?
The motor is in mint condition. The carb was removed and disassembled. I got the motor intact with the carb removed and apart. I put it back together. I don't know if everything is there or not. Anyway when i pump the bulb it fills the bowl and the cylinder with gas. the gas goes straight through and doesn't pump tight. Once i get the gas clear the motor runs till the bowl is empty the fuel isn't pumping normally the engine stops till I pump it up then it floods REAL BADD again.
Anyone know what the problem is?
Thanks
ZITON
Don
[email protected]
662-515-9160
Last edited by FIN; 09-10-2006 at 09:59 AM.
Crappie.com 1K Star General
i use this site alot http://www.themarinedoctor.com/cgi-bin/YaBB.pl/YaBB.pl
[never snap at the hand that feeds ya
Crappie.com 2K Star General
It sounds like something is not allowing fuel into the carburetor. There could be a part missing or have fallen out or broke. I can tell you this-I had the same motor you're talking about years ago and that would scoot across the water. When you get it fixed hold on!
Trophy King II
It sounds like the needle, which is attached to the float is stuck open, or missing.I am going to guess and say there should be a float, a needle valve, a pin to hold them together, a few screws to hold the bowl over these things.i would guess to say its got a low speed and a high speed adjustment screw. Set em at least a turn out each to start it. that is probably about all the parts . try polishihg the needle/and seat so that it is not sticking open.
Billbob LIKED above post
Super Mod and 2014 Crappie.com Man of the Year
* Crappie.com Supporter
FIN, you can get a lot of info on that oldie here. http://forums.iboats.com/bbBoard.cgi
Go to search and type in williams.
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
Crappie.com 2K Star General
Mudwitch, I think you hit it on the head.
I have just gotten a Sears Ted Williams 7.5 hp motor. Sometimes it will run sometimes it won't. Appears to be no spark. Does it need a new magneto? Looking for help. Also does anyone know where parts can be gotten for it?
Super Mod and 2014 Crappie.com Man of the Year
* Crappie.com Supporter
Best to start a new thread as this one is 10 years old.Originally Posted by mdwoods
Fair Winds and Following Seas
Bill H. PTC USN Ret
Chesapeake, Va
Super Moderator - 2013 Man Of The Year
* Crappie.com Supporter
I'd also suggest putting the new thread on the Mechanics forum.
Minnow
What year is it? Try marineengine.com for parts. I would guess that your mag is fine and it probably just needs the points cleaned. Pull the flywheel and take a look. If you have any questions shoot me a pm. I have restored a number of pre 1950s motors so I can probably diagnose the problem.
Posting Permissions
