boat possible for sale

[bfish]

Been thinking about selling my boat. It is set-up for pulling jigs/cranks and pushing. I have not determined a price (and when I do it will be in the classifieds).

1996 Alumacraft Lunker V16 LTD 50th anniversary model (16.75 ft and only 560 lbs).
25 hp Honda tiller with a newish 4-blade prop (better control when trolling). Also have tiny-tach installed. Solo runs around 28-29 mph and trolls around 1.7 mph. 3-blade ran about 33 mph and trolled 1.5 mph. Rated for up to 45 hp tiller.
55 lb, Minnekota foot control bow mount (edge??)
Lowrance x75 and an Eagle (not sure if it works)
Sits in a garage on Hustler trailer with radial tires
Bimini top mounted to tracks (about 3 ft long) so top can be slid towards the bow or stern
Spyderlok 4-pole holder on the bow. I use it for pushing, but it can also be used for spider-rigging
6 rod holders along gunnels, 2 roberts and 4 rod tender brand. They all adjust up/down and swivel 360 degrees.

I will try and find some better pics, but here is what I could find quickly:







I can give test rides on Parksville, Chick, and lower end of Watts Bar

[bfish]

Here is one showing interior (sort of):

[skeetbum]

You're gonna miss it when it's gone. I still miss my last tin boat and it's been gone since '09

[bfish]

You're gonna miss it when it's gone. I still miss my last tin boat and it's been gone since '09

Probably so, but I can fit the three kids and momma in this one. Ideally, I would have multiple boats.

[blueball]

the reels on the front holders ,is that for a mast system ,what type of board do u put on the end of the lines

[bfish]

the reels on the front holders ,is that for a mast system ,what type of board do u put on the end of the lines

The Spyderlok rod holder doubles as a planer board mast. I ziptied 2 very old steel line reels (from the Great Lakes region) to the riser. I also ziptied a pulley to the outer rod holders. I normally run dual boards (both skiboard and riveria brand). I only use them when I have a partner and when pushing cranks is not producing as well as pulling cranks. It allows extra rods. Here is picture to show the general gist: