Is the loop knot the same as a Rapala knot?
Printable View
Is the loop knot the same as a Rapala knot?
Which rods do you catch more fish from, rods straight out back or off the sides? I stagger rods off each side, 10, 7, 5 foot. Occasionally Ill run a rod straight out the back but can never see it. I have a 1436 jon boat and cant see how to effectively run rods out the back off boat and be able to watch them and still be able to see where Im going. Am I missing much be leaving the area under the boat without a hook?
Loop knot video.
How to tie a Loop Knot - YouTube
The rods that produce the most fish mainly depends on how deep the water your fishing is, and how deep the fish are positioned in the water column. If trolling deeper water, for deeper fish any rod will be as good as any other. If trolling a specific contour, using your depth finder as a guide. The back rods will produce best, as the jigs being pulled will travel over the same water the depth finder went over. If fishing shallow water, or fish that are way up in the water column. The outside rods will be best, as the boat will spook the fish, causing them to scatter.
Ink, hit the nail on the head....I will add that I catch a lot of fish on my outside rods (12') due to what Ink was saying and also due to the fact when I make my turns they are affected most (inside/long rods are going deeper and outside/long rods are going shallower---in the turns) This is especially true when going over creek channels/ledge drop-offs....I have also noticed when fish are shallower or higher in the water column that rods placed off the rear of the boat will catch more than rods off the front, which I think is due to fish moving away from boat temporarily. Gabowman did teach me one thing, though....you can catch 'em in 3'fow...so it don't spook 'em too bad.
I have read a lot of this post on this subject but not all. So forgive me if this has been asked. My boat has a foot control trolling motor so I operate off of the front. I do mostly tightlining. Two questions. It seems you would go a little slower pushing versus pulling due to rods in front of trolling motor. I have 6 long poles. Two 14 foot poles, two 12 foot poles and two 10 foot poles. Is it best for my setup to push or would it be ok for me to pull off of the sides. It would seem if I pull of of the front sides I can have issues with when I turn the boat lines going under boat. I also thought I could tightline off of front with four poles and flatline two poles in the back. What do you say?
CK, when longlining you have to always keep the tm running...no exceptions. That would be very hard to do operating a foot controlled tm. In order for you to longline you would need someone in your boat to run the poles while you ran the tm. You also need a way of monitoring your speed and keeping the speed constant. People longline out of the front and back of their boats pulling lines from front holders off the sides of their boats and from holders off the back of their boats. Usually shorter rods are used in the back while longer rods are used off the front. Turns would have to be a bit wider when longlining out of the front of the boat. IMO, with a foot controlled tm spider rigging would be a better choice.