onix/si/360pictures

Quote:

---

Originally Posted by rnvinc

I'm assuming you have the DI ping shut off...??? (no "washboard effect" showing)...

Rickie

---

I posted earlier,that I had my unit on default,but I also did have the di pinging turned off.

Quote:

---

Originally Posted by slabbacks

looks like a few beds had a fish still in it. dont tell me they are already done up that way.

nice shots kosmo, enjoy looking at your post

---

Lot of them have done spond.there will still be more,but I believe that the best (bigger quality)fish have done there thing.
You are correct that you do see some on the beds and theres some that I scared off while scanning over them.

Quote:

---

Originally Posted by genec

Komos, on first set of pics,the third one down,can you explain why 360 show beds side boat on left and si shows the same beds on left about 40 feet behind boat? By the way love all of the pics you put on here,keep it up

---

Im not quite sure what your asking.i went back and looked at that picture.in that shot the boat is moving 3.2 mph, and if I waited for the 360 to complete its update,the beds would show at the bottom. It can be confusing looking at these side by side pictures if your not the person that was there to see what was happening. (Not saying that this happened in any of those) but it can be done. I can get the boat moving,then turn the trolling motor off and turn it to one side and it will scan objects in front and display them as if they were to the side.(the 360 will always be showing the correct position because it is in a fixed position mounted on the transom,while the onix transducer is mounted on the trolling motor were its difficult for me to keep from rotating it during a shot )