Looking For a Good 0 Degree Aftermarket TM Livescope Bracket

Currently, I run Garmin Livescope and Perspective view. Both transducers are on my Ultrex trolling motor. I'm running the LS 34 transducer on my Perspective unit and currently using the stock 8-degree bracket from Garmin on my LS 32 on Livescope Forward view. I do have a new LS 34 to install for my Forward view but have not changed them out yet.
My Perspective view is centered on the trolling motor shaft with the Garmin supplied TM bracket. I'm happy with this set up, but my Forward view transducer is currently mounted to the Port side of my trolling motor shaft with the stock 8-degree bracket.
Does anybody make a bracket that will be 0-degree and still be able to use on a trolling motor shaft?

Quote:

---

Originally Posted by slabbandit

Currently, I run Garmin Livescope and Perspective view. Both transducers are on my Ultrex trolling motor. I'm running the LS 34 transducer on my Perspective unit and currently using the stock 8-degree bracket from Garmin on my LS 32 on Livescope Forward view. I do have a new LS 34 to install for my Forward view but have not changed them out yet.
My Perspective view is centered on the trolling motor shaft with the Garmin supplied TM bracket. I'm happy with this set up, but my Forward view transducer is currently mounted to the Port side of my trolling motor shaft with the stock 8-degree bracket.
Does anybody make a bracket that will be 0-degree and still be able to use on a trolling motor shaft?

---

check with Marc at Cornfieldcrappie, he might be able to help you out. He's known as Cajun fryer on the forum

Garmin
0 Degree Pole Mount (LiveScope™ Plus LVS34) | Garmin

Be aware that if you use the 0° mount on a trolling motor shaft and orient the LVS32 into DownView that the trolling motor housing will block some of your DownView beam ...

That’s the purpose of the 8° shaft mount that comes with LiveScope ...

Rickie

DOMINATOR-LIVESCOPE PLUS LVS34 TROLLING MOTOR QUICK RELEASE Z PKG
– FishObsessed

Sent from my SM-G892A using Crappie.com Fishing mobile app

Yes, I 'm aware thats why they are offset at 8 degrees to clear the motor housing. I would really like for my beam to be perfectly straight up and down over tilted 8 degrees. Right now I don't want to go to a pole just yet as I'm very comfortable with it on my trolling motor. It looks to me that if it was just a little longer away from the shaft a 0-degree bracket would work.
I've even thought of figuring out how to extend it straight out over the nose of the motor housing. Might be risking damage too much with that though.

Or you could mount it directly on the side of the trolling motor housing. I did mine this way. No interference. Just adjust it so it has a zero degree angle. Garmin already supplies you with the clamp and bracket.

Roy, haven't thought of trying that. Thanks!

Mount to side of trolling motor.

Just be careful the bracket is plastic and often breaks. So have a backup. Im looking for a metal one but curious if anyone else might have some suggestions. I’ve seen them zip tied to hose clamped to help.


Sent from my iPhone using Crappie.com Fishing mobile app

I'm a little leary of putting the transducer so near the bottom of my trolling motor. Afraid I'll break it. I do like the Fish Obsessed mount.

Was told today about Beast Innovation"s mount made here in Hot Springs AR about 40 minutes from me. Going to call and check it out tomorrow.