Using a duel injector.

I know many of you beginners have problems using the dual injector the main problem guys is to keep the temperature equal in each of your Pyrex cups you could run it one or 2° off but keep it equal I run mine about 325 to 350 you can go lower but just remember to keep the temperature equal make sure everything is equal you can go down in temperature but just make sure that you keep it equal when you were shooting the dual injector. Make sure everything is also warm including your molds in your injector.

I have an uno injection system. Perhaps next December I will graduate to a dos injector.
Mike

Quote:

---

Originally Posted by shipahoy41

I have an uno injection system. Perhaps next December I will graduate to a dos injector.
Mike

---

What type and injector are you talking about Mike.

I have just a basic one tube injector Bob. Uno is Spanish for one. Dos is Spanish for dual dor two.

Mike

Quote:

---

Originally Posted by shipahoy41

I have just a basic one tube injector Bob. Uno is Spanish for one. Dos is Spanish for dual dor two.

Mike

---

I didn’t know you spoke Spanish Mike .

Still experiencing problems with dual injecting even with equal Temps and heated molds and injectors some shoots I get a couple baits with some bleed over is this normal or am I missing something I'm using pigmentsAttachment 391648

I think you are still having heat problems try to bury the heat a little bit on your plastic and keep trying that a little bit a bleed over sometimes it doesn’t hurt a thing.
Attachment 391650

I see them dual injectors sure are tricky just gotta keep working at It I suppose

roostertail I know this is opposite of what everybody says but give this a try. Cool plastisol down to 310 to 315 and use a cold injector and cold mold...

Finally getting somewhere appreciate everyones help it was a heating issue had to change a setting on my temp gun Attachment 391707

Quote:

---

Originally Posted by roostertail3427

Finally getting somewhere appreciate everyones help it was a heating issue had to change a setting on my temp gun Attachment 391707

---

I’m glad you figured it out I was pretty sure that was the problem.