Printable View
I was loading my jig rack I have used for a while to bake a few heads to tie on and got to looking at a piece of all thread with some nuts on it and this came to mind
Has this been tried yet or has anyone suggested it
It should work for people who like to bake their jigs up right
What do you guys think
It should be cheap enough all thread and nuts are cheap
Attachment 360103
I wanna say I’ve seen that somewhere before probably off this site. Just can’t remember exactly.
Load that all thread up with washers with a nut on each end. Jig, couple 3 washers, jig, washers, etc....tighten the nuts up, good to go.
Copied from this site. Maybe Stumphunter or Nimrod?
I use a toaster oven. You can hang a lot of jigs on the racks that go in them.
I do it the same way.Quote:
Originally Posted by Barnacle Bill
X3!Quote:
Originally Posted by DockShootinJack
Sent from my iPhone using Crappie.com
This is the rack I use most of the time
Attachment 360116
I use all-thread and nuts. been using it for years. You can place them then tighten them off and flip them so any run off goes down the hook shank. I'll post a picture in the next hour or so.
Attachment 360126
Attachment 360128
Now that is an awesome setup stump hunter
You guys are all geniuses. :highfive
The man who taught me how to tie and paint had the same rack as Stump but the bottom AND top were open. So when you tightened it all down, you could just flip it and then put it in oven.
That way you wouldn’t get any “cone heads”from accidental overheating. Excess paint would just head towards the shank of the hook.
To clarify, the end plates moved in as you tightened everything up
Sent from my iPhone using Crappie.com
I'm building one of those! Thanks.
You got my wife’s number? I want you to call and tell her that, I’ve been telling her for years........Quote:
Originally Posted by Slab
You guy's have some great set ups. I use one like Fisher Hawk's, but like Stumps and think I'll make one.