I’ve been using nibbles when I fish jigs and every time I get bit, I need to replace the nibble. Not a big problem,I just keep a jar or 2 on the deck by my feet.
Turns out when the fish are biting pretty good, it’s a lot of bending over, fumbling, time waisted. So I finally got around to making a couple of prototypes today.
I didn’t want to drill new holes so they mount under the main nut on spyderloks. Went ahead and put a couple of slots in for pliers and scissors while I was at it.
Total cost for both, $2.47 for the cutting board from dollar general.
I reply back after I test.
Attachment 358459
Attachment 358460
Attachment 358461
Attachment 358462
Sent from my iPad using Crappie.com Fishing mobile app

