Help I need a good Suzuki mechanic

Does anybody know a good Suzuki mechanic. I have had my pontoon in the shop for 8 weeks and spent $2,000. And it still will not run past 3000 rpm. When it hits 3000 it acts like it goes in limit mode to limit it from over reving. I am frustrated and at wits end. Called does marine which is a Suzuki dealer and they said call them back in September. I have a trailer and will drive to georgia or North Carolina to take it somewhere that will fix it. I have ordered a new limit switch to see if that works.

Might want to ask on the Mechanics forum too: https://www.crappie.com/crappie/mech...-and-trailers/

Gwinnett Marine - New & Pre-Owned Boat Sales, Financing, Parts, and Service in Buford, GA, near Sandy Springs and Johns Creek

Suzuki Marine Services | Savannah, GA

Greg's Outboard Center in Holly Ridge, NC - Boats and Outboards from SeaArk, Bulls Bay, Mercury, Suzuki, and Yamaha

Boat Dealer Wilmington NC | Salt Water Marine | Service Department

Chatlees

Check with Muddy Bay marine in Newberry.

Sent from my SM-G935V using Crappie.com Fishing mobile app

They don't sell Suzuki, but go to Wilson's in Newberry ask for Kevin, he's the only one that works on my motors, and I'm almost 2 hrs away. Also there's a place in Orangeburg that sell Suzuki, but I've never had any dealing with them or there service dept.

Thanks stumpjumper I will give Wilson a call. Orangeburg is where it has been.

. Orangeburg is where it has been.

I was Afraid you was going to say that.

I have a Suzuki now but my old boat had a Johnson 2 stroke, separate tank for gas and oil. I had a problem with the old boat like you described and it was a review limiter. The low oil sensor went bad and we unhooked the wire from it and never had a problem

I have to agree with stumpjumper about Kevin at Wilson Marine. I know he is a wizard when it comes to Mercury and they used to sale Suzuki so I am sure he knows something about them too.

I don't know anything about them, but Doss Marine in Chapin sales and services Suzuki. Might be another option for you.

Sent from my SM-G955U using Crappie.com Fishing mobile app

Talked to Kevin at Wilson and he does not work on them. Don't know what I am going to do to get it fixed.

Dr Don call Bennie at HnL Marine 8642270625. I know he fixed a buddys Suzuki when no one else would work on it. Very honest and has always done me right, tell him Roland Addy sent you. I went through a tough time with boat mechanics a few years ago when out guy died, finally found Bennie though and have been pleased. His shop is on HWY 72 headed toward Greenwood.

Don let me make a call for you tomorrow morning. I should have you an answer by 12:00 and 12:30 at the latest


Sent from my iPad using Crappie.com Fishing mobile app

Thanks everybody for the help. I talked to Bennie at HaL marine and he will look at it and fix it. He thinks it is my high pressure pump. Going to take to him Monday.

Good luck Don. I hope he fixes you up.

Yeah me to Butch this has been a headache and expensive to.

I know about all that. I had my motor rebuilt last year.....TWICE!:yikes Even though I fished from it all this spring I still aint all that comfortable with it yet.